Ricoh FW780 Service Manual page 257

[G]
[A]
[A]
A, B
[B]
[D]
A836I501.WMF
NOTE: To ensure grounding, paint has been removed from the surfaces around
the screw holes [A] (only from the surfaces where the two components
meet) and from the surface around the screw hole [B] at the inside of the
left plate.
1. Temporarily install the top plate [C], left [D], and right side plate [E] (6 screws).
2. Turn the table up-side down in the direction of A.
3. Install the middle plate [F] and rear cover [G] (4 screws each).
NOTE: If the optional copy tray is installed after copier installation, install the front
copy tray stay [I] and rear copy tray stay [J] after step 3.
4. Tighten all the screws until the spring washers [H] of screws are flattened.
5. Put the table the correction way up.
SM
[C]
[F]
[I]
[J]
[A]
[D]
3-13
INSTALLATION PROCEDURE
[A]
[E]
[A]
[C]
[E]
[H]
A836I500.WMF
A251/A252