Xerox 4127 User Manual page 118

Problem Solving
Category
Error Code
Print/Other
016-762 P
016-774 O
016-775 O
016-776 O
016-777 O
016-792 O
016-793 O
016-799 P
024--746 P
024-747 P
024-931 O
024-932 O
024-956 O
024-957 O
7-16 Xerox 4112/4127 EPS
User Guide
Cause and Remedy
Cause: A print language not installed on the machine was
specified.
Remedy: In Specify Print Mode under Port Settings, specify
a print language.
Cause: Compression conversion is not possible due to
insufficient hard disk space.
Remedy: Remove unnecessary data from the hard disk to
increase free disk space.
Cause: Image conversion is not possible due to insufficient
hard disk space.
Remedy: Remove unnecessary data from the hard disk to
increase free disk space.
Cause: An error occurred during image conversion
processing.
Remedy: A portion of the data might have finished image
conversion processing. Check the data.
Cause: A hard disk error occurred during image processing.
Remedy: The hard disk might be defective. When replacing a
hard disk, contact the Customer Support Center.
Cause: Specified job history could not be acquired when
printing Job Counter Report.
Remedy: Specified job history does not exist.
Cause: The hard disk has run out of free space.
Remedy: Either remove unnecessary data from the hard disk
to increase free disk space or initialize the hard disk.
Cause: An illegal print parameter is included.
Remedy: Confirm the print data and option and specify the
print data again.
Cause: A feature (one of paper size, tray, output tray, or 2
sided printing) that is incompatible with the specified paper
quality has been specified.
Remedy: Check the print data.
Cause: An illegal print parameter combination was set. For
example, a non-standard size was specified and
Tray Selection was set to Auto.
Remedy: Check the print data. In the above case, select Tray
5 (Bypass).
Cause: The Staple Waste Container is full or near full.
Remedy: Remove the Staple Waste Container and reinstall a
new one.
Cause: The Staple Waste Container is not attached.
Remedy: Check that the Staple Waste Container is installed
in the finisher and inserted correctly.
Cause: Tray 7 (inserter) is empty/out of paper.
Remedy: Add paper to Tray 7.
Cause: Inserter trays are empty/out of paper.
Remedy: Add paper to the paper trays of the inserter.