Operation Quick Start - Standard Horizon MAGNUM NAV-40 Owner's Manual

Introduction
O Q S
PERATION UICK TART
10
1. Insert batteries into the battery compartment (see page 6).
2. Press and hold in the [ PWR ] key until the MAGNUM turns On (about 2
seconds).
3. The following "Sign-on Message" will be displayed:
ALL INFORMATION IS FOR REFERENCE ONLY.
BY USING THIS DEVICE YOU ASSUME TOTAL RESPONSIBILITY AND
ASSOCIATED RISKS.
After reading the opening message, click the Joystick knob (press inward
momentarily).
4. The MAGNUM will begin operation on the GPS Status page. Wait a few
moments for several GPS satellites to be acquired. If you do not observe the
icons depicting orbiting satellites signal strength appearing on the screen,
you may be in a poor location for satellite reception; try moving to a less
obstructed position. Note: When the MAGNUM is first turned on, it may
take several minutes to compute a fix of your location. This is normal, as the
MAGNUM is downloading "almanac" information from the GPS satellites.
5. Because of the characteristics of GPS, it takes more time to find your loca-
tion when you first turn on GPS unit or you moved long distance and turn on
GPS unit.To shorten the time to acquire the satellites first time after you
moved long distance, we recommned to choose nearest city from POI list in
MAGNUM when you turn it on. Press the [ MENU ] key, move the Joystick
knob downward to select "GOTO" at the top of the screen, then click on
GOTO. Move the Joystick knob upward to select "POI," and click on that.
CAUTION