Fargo DTC400e User Manual page 77

RESTRICTED USE ONLY
Resolving a Invalid Ribbon Error (continued)
Step Procedure
2 Verify that the Ribbon Cartridge installed is designed for the correct Printer
model.
3 Press on the Resume button.
If the issue persists, continue to Step 4.
4 Remove the rear cover and check that the Ribbon RFID cable is securely
connected to the Main Board (J-5) and the RFID Sensor.
•
If the connections are loose, reattach
•
Press on the Resume button..
•
If the connections are good or if the issue persists, continue to Step 5.
5 Replace the Ribbon RFID Sensor.
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
Fargo Electronics, Inc.
4-25