Fargo DTC400e User Manual page 68

RESTRICTED USE ONLY
Resolving the No Mag Installed Error (continued)
Step Procedure
2 Press the Cancel Print button on the Driver Monitor Error Display Message.
3 Reboot the Printer by cycling the power.
4 Verify that the Printer has a Magnetic Encoder installed.
a. Open the front cover.
b. Remove the Magnetic Module cover screw.
c. Remove the Magnetic Module cover.
d. Verify that the Printer has a Magnetic Module installed. (Note: If the
Printer is equipped with a Magnetic Encoder Module, ensure that it is
seated securely into the Magnetic Module docking station. If the issue
persists, replace the Magnetic Module. See the DTC400e service manual
for replacement procedures.)
5 If the Printer has no Magnetic Encoder Module, verify that the encoding data
was sent in error, check the appropriate software user's manual for encoding
instructions.
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
Fargo Electronics, Inc.
4-16