Fargo DTC400e User Manual page 118

RESTRICTED USE ONLY
Reviewing the Telnet Command Table (continued)
Telnet Command
store net addr
mask
gateway
dns
domain
opts
from
ifc mode
from
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
Command Purpose
Store a new IP
address.
Store a new address
mask.
Store a new default
gateway.
Store a new DNS
server address.
Store a new DNS
domain suffix.
Enable or disable
automatic address
assignment using
DHCP. Static (non-
automatic) addresses
will come from the
stored or default
settings, depending on
the other settings.
Restore the network
settings from either the
default settings or the
current settings.
Specify the Ethernet
interface mode as:
automatic, full or half
duplex; 10 or 100 mHz.
Set the Ethernet mode
settings from the
default or current
settings.
Fargo Electronics, Inc.
Command Format
store net addr <ADDRESS>
store net mask <MASK>
store net gateway <ADDRESS>
store net dns <ADDRESS>
store net domain <STRING>
To enable automatic address
assignment:
store net opts dhcp
To disable automatic address
assignment:
store net opts -dhcp
store net from default|current
store ifc mode
auto|10half|10full|100half|100full
store ifc from default|current
5-10