Table of Contents
Advertisement
USB connector pin assignments
Resident code page
|
|
|
|
Thermal printing font
Table 5. 9-pin to 9-pin EIA-232 connector layout (continued)
System Description
Pin 7 - RTS (output)
Pin 8 - CTS (input)
Table 6. 25-pin to 25-pin EIA-232 connector layout
System Description
Pin 2 - Tx (output)
Pin 3 - Rx (input)
Pin 4 - RTS (output)
Pin 5 - CTS (input)
Pin 6 - DSR (input)
Pin 7 - Gnd
Pin 20 - DTR (output)
SureMark printers contain a USB port, if the USB feature is installed. This port is on
the interface card, accessible under the printer without removing printer covers.
Connection to the port can be with either the standard USB Type B connector,
which requires a 24 V power brick, or with the powered USB connector, which
contains 24 V power lines within the communications cable.
The standard USB Type B connector has the following pin functions:
Table 7. Standard USB connector pin assignments
Pin
Signal
1
Vbus (+5 V dc)
2
Minus data
3
Plus data
4
Ground
The code page is controlled by the fiscal printer microcode. Refer to the
programming guide for your printer model and country. (See the Toshiba support
Web site and select Publications.)
There are three font sizes for the resident character set on Model SJ6.
v Font A is 10 dots (wide) × 20 dots (high) with the last 2-dot row used for
descenders.
(1.25 mm × 2.5 mm character height including descenders, 1.25 mm × 2.25 mm
excluding descenders)
v Font B is 12 dots (wide) × 24 dots (high) with the last 2-dot row used for
descenders.
Printer Description
Pin 7 - RTS (input)
Pin 8 - CTS (output)
Printer Description
Pin 3 - Rx (input)
Pin 2 - Tx (output)
Pin 7 - RTS (input)
Pin 8 - CTS (output)
Pin 6 - DSR (output)
Pin 5 - Gnd
Pin 4 - DTR (input)
Appendix C. Technical information
21
Advertisement
Table of Contents
