Canon Mk2500 User Manual page 105

• "Changing character size" (
• "Changing the spacing between characters" (
If "All" is selected on the Seg Length selection display, characters typed exceeding the
specified segment length are deleted. If 2.00 mm is specified as the segment length, all
characters are deleted even when a page containing "6mm 100%" characters exists. For
this page, 2.00 mm is temporarily specified as the segment length and "6mm 100%" is
temporarily specified as the character size and therefore you cannot enter any character.
Select "Automatic" on the Seg Length selection display or change the character size before
entering characters.
It is recommended that you save the file before selecting "All" on the Cut Length selection
display.
For the procedure to follow after selecting "Expansion" on the Plate Printing Area selection
display, refer to "Printing with short pitch width" (
You can adjust the set segment length by ±5%.
• The Print Media selection display appears.
▲
• Press [Enter] to display the Adjustments
display.
This segment length adjustment is intended for use with
labels, and may not produce the corresponding effect with
other media.
▲
• The Length adjust selection display appears.
page 68)
page 69)
▼
▼
page 111).