Barcomed Driver Tab; Introduction; Accessing The Barcomed Driver Tab - Barco CORONIS 1MP System Manual

BARCOMED DRIVER TAB

Introduction

After the BarcoMed Windows Display Controller Driver is installed, a
new Display Properties tab is available for configuring special
features of the BarcoMed Display Controller. Please note that you
must have logged on to Windows using an account with
administrator privileges in order to use the BarcoMed Tabs of the
Windows Display Properties Control Panel to change any display
settings.

Accessing the BarcoMed Driver Tab

1) Open the "Display Properties Control Panel" by right clicking on
the desktop, then select "Properties".
2) Under Windows NT 4.0, Click on the "BarcoMed Driver" tab (see
figure 20 below).
Under Windows 2000 and Windows XP, click on "Settings" tab.
Double click on the rectangle that represents the BarcoMed
Display Controller to bring up its property page. Click on the
"BarcoMed Driver" tab (see figure 21 on the next page).
Figure 20: BarcoMed Driver Tab under Windows NT 4.0
System manual Coronis 1MP
BarcoMed software driver installation
83