Monitor Settings; Use As Logon Screen Saver; Getting Started With The Barco Dpms Screen Saver - Barco CORONIS 1MP System Manual

D P M
O n
S a t n d b - y
S s u p e n d
O f f

Monitor Settings

Select the amount of time the display requires to warm-up. Since all
CRT based displays require some warm-up time before they are at
full performance, this ensures that the display is ready for use at the
beginning of the work day.
If you have a Barco Medical Display, select "Barco Quick Start." If a
non-Barco display is being used, select the amount of time it takes
your display to warm up via the "Monitor Setting" section. Contact
your display vendor for this warm-up time.
On Barco CORONIS displays, the I-GUARD will stabilize the image
within a few seconds after the display returns to the active state so
there is no need for a warm-up time period.

Use As Logon Screen Saver

Check the box to use the BARCO DPMS Screen Saver when no one
is logged into the system.
Uncheck the box to use the default screen saver when no one is
logged into the system.
Getting started with the BARCO DPMS
Screen Saver
The easiest way to get started is to select an existing settings
scheme and then modify it with your preferences. Settings schemes
are separated into two kinds, DEFAULT (global) and PRIVATE
(personal).
Upon installation, three default settings schemes are installed and
no private settings schemes are installed.
Default settings schemes are visible to all users of the system.
However, they can be modified only by users with administrator
System manual Coronis 1MP
S S a t e t P
N o
M i n i
S u
M a
BarcoMed software driver installation
o w r e S a v n i g s
n e
m l a
b s a t t n l a i
i x m u m
M o n t i r o
R e c o v e y r i T
N A /
S h o t r
L o n g r e
L o n g e t s
m e
102