Running Multiple Barcomed 3Mp2Fh, 2Mp2Fh Or 1Mp2Fh Display Controllers In A Single Host - Barco CORONIS 1MP System Manual

1MP2FH setup, connect the secondary display to the other connector
on the display controller.
7. Reconnect the power cord, turn on the power, and boot the system
as usual.
Running Multiple BarcoMed 3MP2FH, 2MP2FH or 1MP2FH
Display Controllers in a Single Host
The physical order of the displays may vary when you are running
multiple BarcoMed 3MP2FH, 2MP2FH or 1MP2FH display controllers.
This is due to the PC's PCI bus control in the system BIOS, and not
the BarcoMed display controller. It may become necessary, depending
on how your PC's BIOS configures the PCI bus, to switch your DVI
display connections to achieve a linear desktop configuration.
System manual Coronis 1MP
Figure 3: The Video Outputs.
Display controller installation
20