Barco CORONIS 1MP System Manual page 105

4. Use the default schemes by selecting one of the three default
schemes. Click "OK". Then Click "OK" again.
Note: If you make any changes to any of the settings of one of the
three default schemes, the Current Scheme field will blank and
you MUST SAVE your changes by clicking on the "Save As ..."
button. When you click on the "Save As ..." button, the name of
the last scheme you used will be automatically displayed, you
can then choose to use that scheme name or enter a new name.
If you enter a name other than one of the three default scheme
names, the program will ask you if you wish to save the scheme
as a DEFAULT scheme (see figure 31 below). Click "Yes" to
save the settings scheme as a DEFAULT scheme, click "No" to
save the scheme as a PRIVATE scheme. After you have saved the
scheme, then click OK and the new scheme will be in effect.
To create a new scheme by modifying one of the three default
schemes please do the following.
1. Open the "Display Properties Control Panel" by right clicking on
an empty space of the desktop and selecting "Properties" from
the drop down menu; then select the "Screen Saver" tab.
2. Select the "BARCO DPMS Screen Saver" in the "Screen Saver"
drop down menu if it is not already selected.
3. Click on the "Settings" button. The "BARCO DPMS Screen Saver
Control Panel" will open.
4. Select one of the default schemes from the "Current Scheme"
drop down menu.
5. Set the Work Schedule by setting the beginning and ending time
of your work day for each day of the week.
6. Select the screen saver you wish to use during the work day in the
"Screen Saver During Work Day" section.
7. Select the amount of time you wish to spend in the Stand-By and
Suspend states after the work day has ended. Please note that
System manual Coronis 1MP
BarcoMed software driver installation
Figure 31
106