Barco PresentationPRO-II User Manual page 32

2. Hardware Orientation
Front Panel Sections
LOGO — press to pend a LOGO transition or select the LOGO source. The button blinks
when selected and the Logo Input Setup Menu appears on the Touch Screen . In
LOGO Chapter 4, refer to the "
Please note:
•
•
•
FULL SCREEN — press to take the selected (blinking) PIP or Key to full screen. In each
case, the source's height will be used as the parameter that defines the full screen size.
FULL
SCREEN
In Chapter 6, refer to the "
CLEAR — press to "pend" the removal of the currently selected (blinking) layer from
Program — in the next transition. For example, you can "clear" a PIP, Key, still frame
CLEAR background, DSK or LOGO. In Chapter 6, refer to the "
page 102 for instructions.
FREEZE — press to freeze the selected (blinking) PIP or Key on Program. In Chapter 6,
refer to the "
FREEZE
RESET — press to reset the current effect (e.g., PIP, Key, crop, etc.) to a nominal default
value. You can think of this function as being "context sensitive" — as it resets only the
current effect, without affecting other modifications.
RESET
In Chapter 6, refer to the "
TRANS — press to transition the pending layer(s) to or from Program — using either a mix
or wipe. The wipe patterns, edge types and transition rates are selected using the Effects
TRANS Menu .
•
•
20
LOGO Input Setup Menu
The logo is the system's highest priority layer, to which you can assign one of
PresentationPRO-II's three internal frame stores.
The LOGO layer is often used as a "black preview" function. If Black is selected
as the "type" on the Logo Input Setup menu, you can fade to black at any time by
pending a LOGO transition.
The logo is not a live input, and does not have an associated key signal.
Important
All layers are maintained underneath the LOGO . For
example, if you have a PIP and a DSK on Program when you
transition to the LOGO , when you mix the LOGO off — the
previous "look" is still there.
Example : If a source's original dimension is 1280 x 1024, pressing FULL
SCREEN expands (or reduces) that PIP to fill the output screen vertically. If
borders are ON , they will be taken into account so that they are visible.
Using Full Screen
Using Freeze " section on page 114 for instructions.
Example : If you adjust a PIP's size, border and shadow, and wish to reset
only the border, navigate to the Border Menu and press Reset .
Using Reset
In Chapter 4, refer to the "
In Chapter 6, refer to the "
operational procedures.
" section on page 82 for details.
" section on page 114 for instructions.
Working with Layers
" section on page 114 for details.
Effects Menu " section on page 53 for menu details.
Working with Transitions
PresentationPRO-II • User's Guide
" section on
" section on page 115 for