Table of Contents
Advertisement
2. Hardware Orientation
Front Panel Sections
pçìêÅÉ=pÉäÉÅíáçå=_ìë
The figure below illustrates the Source Selection Bus .
1
2
Figure 2-4. Source Selection Bus
Each button represents an input that you can assign to a PIP or a key.
•
•
Press a button on the Source Selection Bus to assign the source to the blinking PIP or
Key effect in the Layer Functions Section .
•
•
•
In Chapter 5, refer to the "
all source setup procedures.
18
~
The Bottom knob is used to adjust the adjacent parameter, as labeled
on the Touch Screen.
Important
There is no Enter button. If you adjust a value with the
knobs, that function or value is immediately active.
Source Selection
3
4
Buttons 1 through 8 correspond to the eight analog inputs on the rear panel.
The SDI button corresponds to the SD-SDI input (SDI Model) or the SD-SDI / HD-
SDI input (HD Model) on the rear panel.
A source button that is blinking indicates that the source is "pending." It has been
assigned as the next PIP or Key source, and can be taken to Program with the
next transition.
When a source button is lit solid, the source is on Program. It cannot be modified
until its associated PIP or Key button is pressed and blinking.
One solid source (Program) and one blinking source (pending) can appear on the
Source Selection Bus simultaneously.
Comprehensive Input Setup
5
6
7
" section on page 90 for details on
PresentationPRO-II • User's Guide
8
SDI
Advertisement
Table of Contents
