Using Remote Control - Barco PresentationPRO-II User Manual

Table of Contents

Advertisement

6. Operations

Using Remote Control

rëáåÖ=oÉãçíÉ=`çåíêçä
When PresentationPRO-II is controlled from an external controller, the Remote Control
Menu is used to set the unit ID and enable/disable remote control itself. Please note the
following prerequisites:
Use the following steps to place PresentationPRO-II under remote control:
1.
2.
3.
4.
Use the following steps to reestablish local PresentationPRO-II control:
1.
116
Ensure that you know the unit IDs currently in use by the external controller. The
external controller will not allow PresentationPRO-II to connect if a duplicate ID is
assigned.
If an external router is to be connected to PresentationPRO-II, ensure that the
proper physical connections have been made, and that the router is properly
configured from the external controller.
Press { HOME } > { REMOTE CONTROL } to access the Remote Control Menu .
Set the Unit ID to a value that is not used within the external controller's system.
Scroll to the Remote Control line turn it ON .
Important
When remote control is on, the { HOME } buttons disappears,
the PresentationPRO-II front panel is disabled, and all control
originates from the external controller.
In the " Status " section, verify the following:
~
Connection status with the external controller.
~
Ctrlr IP — the IP address of the external controller.
~
Destination — the destination assigned to PresentationPRO-II.
~
Router — the utilization of routers, either internal or external.
On the Remote Control Menu , scroll to the Remote Control line turn it OFF . The
{ HOME } buttons reappears, the PresentationPRO-II front panel is re-enabled, and
all control now originates locally.
PresentationPRO-II • User's Guide

Advertisement

Table of Contents
loading

Table of Contents