Table of Contents
Advertisement
`K==réÖê~ÇáåÖ=pçÑíï~êÉ
Serial Upgrade Method
Figure C-2. Flash Loader Status Lights, Normal Condition
10. To troubleshoot the serial connection:
H
O
M
E
B
A
C
K
Figure C-3. Console Port Setup Menu (sample)
11. To upload files to the PresentationPRO-II unit, click the " Open script file to read
12. In the dialog, select " Upload_All.sld " and click Open . The PresentationPRO-II
138
•
TXD and RXD should be green. They will flash if Enter is
pressed.
c.
Press Enter a few times to display the system prompt " # " on screen.
d.
If the prompt does not appear, continue with step 10 (troubleshooting).
e.
If the prompt appears, continue with step 11 (uploading files).
a.
If the DCD and CTS status lights are green, re-check the communication
settings in the loader, and verify that the COM port and Baud Rate
settings are correct.
b.
To verify PresentationPRO-II communication settings, on the front panel
of the PresentationPRO-II unit press { HOME } > { SYSTEM } >
{ CONSOLE } to display the Console Port Setup Menu .
CONSOLE PORT SETUP
Baud Rate
Data Bits
Parity
Stop Bits
c.
On the menu, ensure that the following settings are selected:
•
Baud Rate = 115200
•
Data Bits = 8
•
Parity = NONE
•
Stop Bits = 1
d.
Repeat steps 7 and 8 above, then re-check the status lights.
e.
With communication status OK, continue with step 11 .
and upload " button.
unit should immediately display the " System in LOADER MODE " message.
115200
N
A
V
8
NONE
1
A
D
J
PresentationPRO-II • User's Guide
Advertisement
Table of Contents
