Setting Up The Dsk; Using The Dvi Input As The Dsk; Using A Still Frame As The Dsk - Barco PresentationPRO-II User Manual

Table of Contents

5. System Setup

Setting up the DSK

pÉííáåÖ=ìé=íÜÉ=aph

With PresentationPRO-II, you can use the DVI input or a still frame as the DSK source.

You can also change which source you use for the DSK during the course of a live

production — provided that the DSK has been properly set up.

Select the procedure below for the type of DSK that you wish to set up:

•

rëáåÖ=íÜÉ=asf=fåéìí=~ë=íÜÉ=aph

This procedure enables you to set up the DVI source as the DSK's input type. It is

recommended that you perform these steps as a setup procedure. However, once the

DSK is set up, during live production you can switch it between a captured still frame and

the DVI source.

Use the following steps to set up the DVI input as your DSK source:

Note

Remember that the BG/DSK input is shared between BG and

DSK . If you elect to use a "live" DVI input as the background,

it cannot be used as the DSK simultaneously.

Ensure that the PresentationPRO-II EDID is properly programmed. Refer to the

Programming EDID

" section on page 93 for instructions.

If you have not already set up the BG/DSK input as a DVI source, follow the setup

procedure as outlined in the "

on page 94.

In the Layer Functions Section , press BG/DSK . The button blinks and the BG/

DSK Input Setup Menu appears.

Scroll to the Mode line and select DSK .

Scroll to the Type line and select DVI .

Press { KEY } to display the DSK Adjustment Menu .

Adjust key parameters as required. In Chapter 4, refer to the "

" section on page 78 for details.

Using the DVI Input as the Background

PresentationPRO-II • User's Guide

" section

DSK Adjustment

Table of Contents