Connecting The Cables - Barco Coronis 3MP Installation & User Manual

Should you change the panel orientation without tilting it
first, you might irreversibly damage the tilt & swivel
mechanism.
3. To change from portrait to landscape, turn the panel
counterclockwise while tilting it slightly.
4. To change from landscape to portrait, turn clockwise.

Connecting the cables

To get access to the connectors, open the cover of the connector
compartment by pulling down the 2 clips of the cover.
The signal cables can be routed inside the display foot. Therefore,
remove the foot cover before connecting the cables (see "Before
installing the display").
To connect DVI cables:
1. Connect one end of the DVI cable to the DVI input (6) of the
display.
2. Connect the other end of the DVI cable to the video output of
your DVI signal source.
3. Route the cable so that it enters the connector compartment
at the place where the cover is bulged.
Figure 9
Installation
27