Barco Coronis 3MP Installation & User Manual page 37

Please refer to your application manuals for information on
the correct Palette and Drawing modes to select.
6. When the driver setup is complete, click the Finish button.
The Barco Product Installation Wizard will now guide you
through the installation of MediCal QAWeb, MediCal Pro, or
NioWatch, BarcoMed SelfExam, and the Barco on-line
documentation.
7. When the Setup complete message appears, select Reboot
System Now and click Finish.
Automated display configuration
Once the drivers, software and documentation have been
installed and your system has been rebooted, the Barco Monitor
Plug and Play Software should automatically detect your Barco
displays and attach them to the desktop with the correct
resolution. If the Barco Monitor Plug and Play Software fails to
detect your Barco displays or fails to attach them to the desktop
correctly please refer to the section, Setting the resolution of
your C
ORONIS
section of this manual.
Reinstalling drivers
You can install new drivers or reinstall existing drivers at any
time by using the Barco Set-up wizard on your Barco system CD-
ROM, see Installing the B
and software on page 35 of this manual.
Uninstalling the drivers and software
To un-install the B
software or documentation, please use the Windows Add/
Remove Programs utility. This can be found in the Windows
Control Panel.
Note: If you installed your
drivers with DualView enabled, the wizard may warn you that
DualView must be disabled before the drivers can be
3MP display on page 77 in the Troubleshooting
ARCO
M
ARCO EDICAL
B
ARCO
M display controller drivers
ED
I D S
MAGING ISPLAY YSTEM
M I D
EDICAL MAGING
drivers,
S
ISPLAY YSTEM
37