Barco Coronis 3MP Installation & User Manual page 78

display of the BarcoMed C
working with by right clicking on the rectangle that
represents it, deselect "Attached" and click the "Apply"
button.
Note:
display connected to a particular controller, you may need to
temporarily make another display the primary display
4. For the display which is still attached click Click on the
"Advanced" Button.
5. Select the "Adapter" tab and then click on the "List All
Modes" button. Select the resolution and refresh rate that
your Coronis 3MP display supports from the dialog box and
click "OK".
Note:
display is the First View or the Second View attached to the
display controller. Please make a note of this, so that you can
arrange the displays in the correct order later if necessary.
6. Click "OK" on the bottom of the Adapter Control Panel. If the
"OK" button on the bottom of the Adapter Control Panel is
not visible, press the "TAB" key once and then press
"CTRL"+"Enter" to select "OK".
7. Click "OK" in the "Windows will now apply your new
desktop settings" dialog box. Your Coronis 3MP display
should now synchronize and display the Windows desktop.
8. Click "Yes" when asked, "Your desktop has been
reconfigured. Do you want to keep these settings?"
To set the resolution of the second display attached to the
BarcoMed display controller you are working with, go back to
the "Settings" tab of the "Display Properties Control Panel".
If necssary attach the second display you detached in step 2
above, by right clicking on the rectangle that represents it
and selecting "Attached".
Now repeat steps 5-8 above for this display.
78
Since Windows will not let you detach the primary
In the Adapter box, the Adapter string shows if this
Single Source Master
display controller you are
ORONIS