Barco Coronis 3MP Installation & User Manual page 17

Figure 3: PCI and RAID Controller Slots
Install the BarcoMed C
following these steps:
1. Turn off the power to your computer and disconnect the
power cord, however make sure that the computer chassis is
still grounded.
2. Remove the chassis cover according to the manufacturer's
instructions. Be sure to observe safety warnings.
3. If you have decided to use the on-board VGA capabilities of
the BarcoMed C
the BarcoMed C
any VGA display controller(s) that are currently installed in
the computer or disable any VGA controllers that are
integrated into your PC's motherboard.
4. Install the BarcoMed C
either 64-bit or 32-bit (see figure 3, for examples of slots).
Be sure that the display controller is seated firmly in the slot.
5. Secure the card to the chassis with the PC's I/O panel
mounting screw, and replace the chassis cover.
6. Connect the primary display (left most display in a linear
configuration, top most in a vertical configuration) to the
uppermost connector on the BarcoMed C
farthest from the motherboard – "Head 1" in figure 4
BarcoMed C
ORONIS
controller in your computer
ORONIS
(see Using the VGA capabilities of
ORONIS
on page 16), you must now remove
ORONIS
Controller into a free PCI slot,
ORONIS
display controller installation
(the output
ORONIS
17