Barco Coronis 3MP Installation & User Manual page 77

Setting the resolution of your C
In order to set the resolution of your C
Note:
be logged in using an account with administrator privileges.
1. Open the "Windows Display Control Panel" by one of the
two methods below:
a) Start > Settings > Control Panel > Display
or
b) Open the "Display Properties Control Panel" by right
clicking in an empty area on the desktop, then select
"Properties".
2. Click on the "Settings" tab.
3. Select the rectangle that represents the Barco Coronis
display whose settings you wish to change.
If you are using the VGA capabilities of your
Note:
BarcoMed C
ORONIS
display may be set to a VGA resolution of "640 x 480" pixels with
16 colors and a default refresh rate. If your BarcoMed C
controller is not running VGA, the display may not be enabled
yet. To enable the display, check the "Extend my Windows
desktop onto this monitor" checkbox, but do NOT click the
"Apply" button at this time.
If you installed your B
SingleView mode (default for Windows 2000) there will be
one rectangle for the virtual display representing the two
heads controlled by each BarcoMed C
controller.
If you installed your B
DualView mode (default for Windows XP) there will be a
rectangle representing each head controlled by each
BarcoMed C
you have only one display connected to your
BarcoMed C
controller cannot be enabled at the same time unless their
display properties match. If necessary detach the second
ORONIS
display controller, the resolution for the first
C
ARCO ORONIS
C
ARCO ORONIS
display controller. This will be true even if
ORONIS
controller. Both displays of a display
ORONIS
3MP display
ORONIS
Display System drivers in
display
ORONIS
Display System drivers in
3MP you must
ORONIS
77