Avocent DSView 3 Installer/User Manual page 90

72 DSView 3 Software Installer/User Guide
If you selected Do Not Use SSL or Use SSL in Trust All Mode, go to step 15.
10. Click Certificates. The Authentication Service Certificate Management - LDAP window will
open and list all servers that belong to the domain. A status of Trusted indicates the certificate
is trusted, based on the certificate policy (see System certificate policy and trust store on
page 27); Untrusted indicates the certificate cannot be trusted.
11. To register certificates, click the checkbox to the left of the server IP address(es). To select all
server IP addresses on the page, click the checkbox to the left of the IP Address heading.
12. Click Register to register the certificates. The Accept SSL Certificate window will appear.
13. Click Save to store the certificate values to the DSView 3 software database on the host.
The Certificate Management window will open if only one certificate was selected. If more
than one certificate was selected, each will appear in order in subsequent Accept SSL
Certificate windows.
14. To unregister one or more certificates, check the checkbox to the left of the server IP
address(es). To select all server IP addresses on the page, click the checkbox to the left of the
IP Address heading.
15. Click Unregister to unregister the certificates.
16. A confirmation message box will appear. Confirm or cancel the operation.
17. Click Close. The User Authentication Services window will open.
To change user schema settings for the LDAP external authentication service:
1. Click the Users tab.
2. Click Authentication Services in the top navigation bar. The User Authentication Services
window will open.
3. Click the name of the LDAP service. The side navigation bar will change to include the name
of the LDAP service at the top and, below the name, the information you may define.
4. Click Schema in the side navigation bar. Users will automatically be selected and the
Authentication Service User Schema - LDAP window will open.
5. Type the Base distinguished name (DN) from which to begin searches. This is a required field
unless the Directory Service has been configured to allow anonymous search. Each Search DN
value must be separated by a comma.
6. Type the key attribute. The default value is common name (cn).
7. Type the object class. The default value is person.
8. Type the full name attribute for the user. The default value is surname (sn).
9. Click Save and then click Close. The User Authentication Services dialog box will appear.
To change group schema settings for the LDAP external authentication service:
1. Click the Users tab.
2. Click Authentication Services in the top navigation bar. The User Authentication Services
window will open.