Avocent DSView 3 Installer/User Manual page 304

286 DSView 3 Software Installer/User Guide
To add the task:
1. Click the System tab.
2. Click Tasks in the top navigation bar. The Tasks window will open.
3. Click Add. The Add Task Wizard will appear. Click Next.
4. The Select Task to Add window will open.
a. Select Migrate Units from the drop-down menu.
b. Type a 1-64 character name for the task.
c. Click Next.
5. The Select When to Run the Task window will open. Select a time to run the task (see
Specifying when to run tasks on page 278), then click Next.
6. The Select Unit Group window will open. Select Units Needing Migration or select a
particular unit group from the menu. Then click Next.
7. The Select Appliance Type window will open.
Select the type of CCM appliance to migrate: CCM850, 1650 or 4850, and then click Next.
You must create a separate task for each type of CCM appliance you wish to migrate. For
example, if you wish to migrate CCM850, 1650 and 4850 appliances, you must create three
Migrate Units tasks.
8. The Select Appliances window will open. The Available Appliances list will contain only units
with a status or Migration Needed that match the selected type found in the unit group
specified in the previous step.
a. Select the specific CCM appliance to migrate. Multiple appliances may be selected by
pressing
b. Click Add. The appliances will be moved to the Appliances to Configure list.
c. Click Next.
9. The Select Options for Migration window will open.
a. If you want all the CCM appliances you are migrating to only be accessible by this
DSView 3 software system, enable the Enable secure mode checkbox. If you want all
CCM appliances you are migrating to be accessible by any DSView 3 software system,
disable this checkbox.
b. If you want to add target devices that have default names to the DSView 3 software
system, enable the Enable target devices that contain default names to be added
checkbox. To exclude target devices that have default names, disable this checkbox.
c. To merge target devices with the same name, enable the Allow target devices with the
same name to be merged into a single target device checkbox. If you don't want to merge
them, disable this checkbox.
d. Click Next.
while clicking on the managed appliance names.
Ctrl