Avocent DSView 3 Installer/User Manual page 151

The following fields may be displayed in the Appliance Serial Ports window. Use the Customize
link to add or remove fields in the display. See Using the Customize link in windows on page 12.
• Type - Displays the port type (CLI, SPC or Standard)
• Baud - Displays the baud rate of the serial port
• Data Bit - Describes the data bit rate of the serial port
To change the general settings for a CCM or CPS appliance physical serial port:
1. In a Units View window containing appliances (see Accessing Units View windows on
page 88), click on the CCM or CPS appliance name.
2. Click Appliance Settings in the side navigation bar and then click Ports and then click Serial.
The Appliance Serial Ports window will open.
3. Click on the name of a serial port. The Appliance Serial Port General Settings window
will open.
4. Change the settings as needed:
• If you change the appliance name and the automatic name pull feature is enabled, see
Automatic name pull on page 106 for the effect.
• Port type:
• Standard - For accessing a connected serial device using Telnet or SSH.
• (CPS appliances only) Standard Command Line Interface (CLI) - For a serial
connection for a local terminal. Only one port may be defined as a CLI port. If a
second port is defined as a CLI port, the previously defined CLI port will be changed
to a standard port.
• Time-out that specifies the number of idle minutes the CCM appliance will wait before
dropping a connection to the port.
• CLI access character used to access CLI mode on a serial device. The (^) character
represents the
CLI mode.
• Telnet port that will be used to access the serial port. The default is 3001.
• Whether the port should use a DTR signal. If set to DTR, the appliance will report target
devices as ON if the signal given matches the state given. Otherwise, the appliance will
report the target device power as OFF.
• Power signal type to be used for power status monitoring of the port.
5. Click Save and then click Close. The Appliances Serial Ports window will open.
6. Click Close. The Units View window will open.
To change the communication settings for a CCM or CPS appliance physical serial
port:
1. In a Units View window containing appliances (see Accessing Units View windows on
page 88), click on the CCM or CPS appliance name.
key. For example, specifying ^D means that pressing
Ctrl
Chapter 4: Managing Units
Ctrl+D
133
will enter