Maintenance
To set Syslog via DHCP ore OM Configurator has the advantage, that syslogs are available in
earlier states of IP DECT base station start up.
The level of syslog messages in the default state allows the user, to have control about the
general state of the system and major failures. If it is wished to increase the level for diagnostic
reasons, it can be done via telnet user shell by increasing the SPY level of subsystems (see
Telnet user shell
can harm the system operation.
You can also read syslogs if you type the command "logread" within telnet user shell.
Telnet user shell
Each IP DECT base station (ADMM included) offers a lot of command within the telnet shell.
Most of them are useful for diagnostic and may help experts, to resolve failures. Some
commands can harm the system operation.
94 Avaya IP DECT Installation, Administration, and Maintenance
on page 94). This should be only used by the support organization because it