Avaya Communication Manager IP DECT Installation, Administration And Maintenance Manual page 34

Installation and Configuration
Press send Button to transmit parameters into a IP DECT base station.
The configuration can only set after power up or at retry phase (led flashing 0,25 Hz) or in kernel
mode, please see section
Configurator Tool waits 2 s and retry transmitting data 3 times.
If you want to read the configuration parameters from IP DECT base station set MAC address
and additionally the IP address and press the list button. All parameters will list in OM
Configurator tool.
Press reset button to clean all input fields and additional parameters.
Boot Parameters (comply with DCHP option)
Parameter
use_local_cfg
ip
subnet
siaddr
boot_file
ommip1
router
dns
domain
broadcast
ntpsrv
syslogip
syslogport
vlanid
The configuration can be verified at the IP DECT base station using the telnet interface, please
see section Static local configuration
DECT base station, please see section
34 Avaya IP DECT Installation, Administration, and Maintenance
State graph of the start up phases
Type
mandatory
mandatory
mandatory
mandatory
mandatory
mandatory
optional
optional
optional
optional
optional
optional
optional
optional
on page 80. It is also be possible to reset all data at the IP
Removing the local configuration
on page 32 for details. The
Meaning
the local configuration settings should be used at
booting or not.
ip address
subnet mask
ip address of tftp server
the boot file reading from the tftp server at startup
ADMM ip address
default gateway
dns server
domain name of the network
the broadcast address for that network
ntp server IP address
Syslog IP address
Syslog port
VLAN Identifier
on page 81.