Avaya 3711 Site Survey Mode; Avaya 3711 Master Reset - Avaya Communication Manager IP DECT Installation, Administration And Maintenance Manual

Avaya 3711 Site Survey Mode

You can put the Avaya 3711 in the "site survey mode" with few keystrokes. In this mode the
phone will display the IP DECT base stations and the actual field strength of the receiving signal
in dBM.
1. Short press the "Menu" soft key
2. Enter the following key sequence: R***76#
3. Select Site Survey
4. Press OK.
To leave the site survey mode switch the phone off and on again.
The following display is shown on the Avaya 3711:
The telephone is actually connected to IP DECT base station with the number 02. Also visible
IP DECT base stations are the 01 and 00. The number 10FFF221 02 on the upper right side
refers to the PARK
1F-10-F2-FF-21 of the IP DECT system and the number 02 refers to the IP DECT base station
where the telephone is locked to.

Avaya 3711 Master Reset

You can reset the Avaya 3711 settings to default with few keystrokes.
1. Short press the "Menu" soft key
2. Enter the following key sequence: R***76#
3. Select Master Reset
4. Press OK.
5. Press OK again.
Avaya 3711 maintenance and diagnostic
Issue 1 August 2006 87