Ip Dect Base Station Configuration - Avaya Communication Manager IP DECT Installation, Administration And Maintenance Manual

Installation and Configuration
The same popup window could be opened for an existing IP Region by pressing the tool icon
of the appropriate Region.
The checkbox 'ADMM Region' is only available if the ADMM is running on a PC. Otherwise the
system will detect the ADMM Region by itself.
An IP Region could be deleted by pressing the trash can icon
for confirmation showing the current configuration of this IP Region.
Note:
Deleting an IP Region from the system requires all related IP Trunks and IP
Note:
DECT base stations to be deleted first. This is indicated with a crossed out trash
can icon

IP DECT base station Configuration

All configured IP DECT base stations are listed in tables grouped to clusters by its topographic
relations. The IP DECT base stations are sorted by their ethernet addresses.
To ensure correct hand over of a telephone during a call, all involved IP DECT base stations
must deliver the same clock signal to the telephone. This is achieved by placing the IP DECT
base stations so close to each other, that every IP DECT base station recognises at least one
other IP DECT base station through its air interface.
There are conditions where this is not possible, for instance with IP DECT base stations at
remote locations. In this case the IP DECT base stations shall be grouped to different clusters.
The Avaya DECT Mobility Manager will not try to synchronise IP DECT base stations over
cluster borders.
All not empty clusters are displayed in the navigation bar on the left side.
50 Avaya IP DECT Installation, Administration, and Maintenance
.
. A similar popup window asks