Table of Contents
Advertisement
Installation and Configuration
Booting Overview
Booting can be in two steps:
Starting the boot process
●
Starting the application
●
Booter:
The IP DECT base station has only a little standalone application built into the flash. This
software realises the so called NETBOOT process.
On start up each IP DECT base station try to determine its own IP address and other settings of
the IP interface from the configuration settings in the internal flash memory. When no settings
are available or these settings are disabled, the IP DECT base station try to determine this
settings via DHCP.
The IP DECT base station gets the application image file from the TFTP server.
Application:
After starting the application image the IP DECT base station checks the local network settings
in his internal flash memory once again. When no settings are available or they are disabled it
starts a DHCP client to determine the IP address of the ADMM and other start up settings.
Startup of Avaya IP DECT Mobility Manager
ADMM in IP DECT base station mode
There is no difference in booting that IP DECT base station, which is chosen to be running in
ADMM mode from those which are in the IP DECT base station only mode.
The decision is driven by the ADMM IP address, which is read:
within the local network settings, if active.
●
via DHCP request.
●
That IP DECT base station which has the same IP address as the ADMM IP address, is running
as the ADMM.
ADMM in Host-Mode
In this case the ADMM Software has to be installed on PC running with Linux Red Hat. The
essential network settings the ADMM is working with are depending on the configuration of the
PC Kernel.
24 Avaya IP DECT Installation, Administration, and Maintenance
Hide quick links:
Advertisement
Table of Contents
