Build A Demo Platform: Assemble Two Boards; Connect Cpu Board To Personality Board - Freescale Semiconductor i.MX27 PDK 1.0 Quick Start Manual

3. Connect the regulated 5V power supply to the appropriate power adapter. Plug the
power adapter into an electrical outlet and the 5V line connector into the J2 (5V
POWER JACK) connector on the Debug board. See Figure 3-5.
4. Start a serial console application on your host PC with the following configuration
Table 3.2 Serial Console Configuration
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
5. On the Debug board, switch the power switch (S4) to 1.
6. The OS image pre-loaded in the 3-Stack board will boot and the debug messages from
the bootloader should now appear on the serial console application on your PC.
Build a Demo Platform: Assemble Two
Boards
This section explains how to make a demonstration platform using the Personality and
CPU boards.
To make a demonstration platform, the CPU board is directly connected to the Personality
board using the 500-pin connector; the Debug board is not used.
NOTE

Connect CPU Board to Personality Board

Connect the CPU board to the Personality board. The connector is keyed to avoid
misconnections, so that there is only one way to connect the CPU board to the Personality
board.
115200
8
None
1
None
If your system is already configured as a development platform (using all three
boards), disconnect all boards from each other.
i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0

Build a Demo Platform: Assemble Two Boards

Build the Platform
21