Downloading Multimedia To The 3-Stack Board; Using Active Sync - Freescale Semiconductor i.MX27 PDK 1.0 Quick Start Manual

Downloading Multimedia to the 3-Stack
Board
There are three ways to load multimedia content to the 3-Stack board using the Windows
Embedded CE 6.0 image provided:

• Using Active Sync

• Using an SD Card
• Using a USB Card
Using Active Sync
Active Sync is a very useful tool to use with a Windows Embedded CE 6.0 device. To
obtain the Active Sync download and instructions, go to:
http://www.microsoft.com/windowsmobile/activesync/activesync45.mspx/
Once Active Sync is installed, you can set up communication between your host PC and
the 3-Stack board.
To establish a communication between the Host PC and the 3-Stack board, follow these
steps:
1. Make sure that the 3-Stack board is ON and running the Windows Embedded CE 6.0
image.
2. Make sure that Active Sync is running on your host PC (the Active Sync icon should
appear gray on the Windows task bar).
3. Use the A to mini AB USB cable provided in your i.MX27 MAX WPDK kit and
connect the mini AB end to the J10 USB OTG connector on the Personality board,
then connect the other end to the any available USB port on your Host PC.
Windows will recognize the 3-Stack board as a Windows Embedded CE 6.0 Device
and the Active Sync wizard will appear on the Host PC
i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0
Using the Demo Image

Downloading Multimedia to the 3-Stack Board

(Figure 4.3).
27