Using the Demo Image
This chapter explains how to use the touch panel and stylus to load the multimedia content
to the 3-Stack board, using the provided demo image.
Touch Pad Calibration Tool
After you have assembled the 3-Stack board and powered it up, the Windows Embedded
CE 6.0 image that was loaded to the board will boot up. The first image you will see is the
touch pad calibration tool, which displays a cross in the center, as shown in the partial
screen image in
Figure
4.1.
Figure 4.1 Touch Pad Calibration Tool
i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0
4
25