Table of Contents
Advertisement
Chapter 2 Before Installation
Before installation ISDN T/A 128 adapter, you need to check the package contents,
apply an ISDN BRI line, get a NT1 device (for ISDN T/A 128 ST adapter only) from your
phone company or retailed stores, and apply an Internet access account (if Internet
access required).
After you prepared the above items, you can start your environment setup. If you
purchased the adapter is " DV" model, you can connect your analog device to the RJ-
11 jack (in the UK an adapter is supplied).
Package Checklist
In your ISDN T/A 128 package, you will find the following contents.
u
ISDN T/A 128 adapter 1 piece.
u
Installation Disk of CD-ROM for Windows 3.1, 95, and NT.
u
RJ-45 cable 6 feet for ISDN connection.
u
RJ-11 cable for a/b port connection (DV model only).
u
USB cable (USB model only)
u
(Quick) Installation Guidefor ISDN T/A 128 adapter.
u
RJ11-BTS adapter
Suggested System Environment
u
Hardware
u
Software
ISDN BRI Line
Before running the ISDN T/A 128 adapter, you need to get an ISDN BRI (Basic Rate
Interface) line from your local telephone company. Sometimes, your ISP may, upon
your request, order an ISDN BRI line for you when you apply an ISDN Internet access
account.
You should get the subscriber information from your ISDN telephone company, who
may inform you about your ISDN central switch type and SPID (Service Profile Identifier)
number, when you are in the US country.
UK only
phone adapter.
IBM PC (or compatible computer) with 16 MB or more of RAM,
486 CPU or later capable of running Microsoft Windows.
Microsoft Windows environment (Linux is the optional O.S.).
4
Advertisement
Table of Contents
