Table of Contents
Advertisement
If you want your analog device always ringing when receiving an incoming call,
please keep this field blank.
EURO ISDN switch type with A-law Codec. The
point to point mode, you may set TEI value also if phone company specifies the TEI
value to you. Otherwise, let it as default (blank). The
provide X.25 on D channel service and specify the TEI value also. Please leave it as
default value (blank) if it is not available in your ISDN service list.
After configuring the switch type, Windows 95 will request to restart system. After
3.
restart the Windows, if you choose the " DV" model then you can connect a standard
analog telephone set into RJ-11 jack and should be able to hear the dial tone from the
telephone handset.
If you already installed the ISDN Accelerator Pack 1.1 (MSISDN11.EXE) or Dial-Up
4.
Networking 1.2 (MSDUM2.EXE) in the Windows, then directly jump to the
application environment setup section.
connection icon in Dial-Up Networking folder, if you see the " set additional devices" in
the general subwindow or " MultiLink" tab, it means your Windows 95 system already
support NDISWAN interface, please jump to the application environment setup section.
To update the Dial-Up Networking to support 2B channel (MLP) connection and
NDISWAN Miniport interface you will need to install the Win95 MSISDN11.EXE
(version 1.1 or above) upgrade pack. You can get the file from our Windows 95
installation diskette and also accessible from Microsoft web site.
MSISDN11.EXE or MSDUM2.EXE program
Please reboot your PC for effectively ISDN Accelerator Pack features.
5.
Application Environment Setup
After you complete the ISDN T/A 128 driver installation, you can execute the applications
based on the WinISDN and CAPI interfaces. Of course, you need installation the software
before executing the applications, please see the example of Appendix C for RVS-COM (lite
version) software installation. In Windows 3.1, you need to run the AT Console to enable
the COM port emulation capability. Under Win95 the COM port emulation is automatically
loaded at startup.
You can choose the either way of NDISWAN and virtual modem to connect to the
Internet or remote LAN.
RAS, we suggest that you setup and use the NDISWAN Miniport adapter interface.
Using the NDISWAN Miniport driver is the Microsoft preferred connection method.
If you want to execute the current modem applications, eg. Microsoft's
HyperTerminal or PC Anywhere, you should setup and use the virtual modem
interface through our COM port emulation function
For the UK and most European countries select the
If you want to execute the Internet related applications or
12
PTP mode
sets the ISDN line as
X.25 on D
You may check from the property of
and follow the installation instructions.
(we named the virtual modem).
enables driver to
Run the
Advertisement
Table of Contents
