Table of Contents
Advertisement
Installation for Windows 95 Environment
This section includes the installation of ISDN T/A 128 adapter and application environment
setup. The supported application interfaces including WinISDN, CAPI 2.0, NDISWAN
Miniport adapter, and virtual modem in Windows 95.
Please read the following Windows 95 installation steps and setup procedures of the
NDISWAN Miniport adapters and virtual modems.
Installing and Configuring the Drivers
After you have inserted the ISDN T/A 128 adapter, switch computer power on and allow
1.
Win95 to startup. When the Windows 95 system starts it should auto-detect a new PnP
card and request you to install its driver. Please insert ISDN 128K driver diskette/CD
into appropriate disk drive,
diskette/CD, then Windows 95 system will automatically process the necessary
installation steps.
Please refer figure 3-3 for ISDN Configuration dialog box. In Windows 95 system, you
2.
can set up (or change) the ISDN configuration of Switch Type, values of MSN and SPID
through the following procedures. Start
Manager
à
ISDN Card
This features of ISDN configuration in Windows 95 is similar with the installation in
Windows 3.1 environment as figure 3-1.
DV model and determines which telephone number to associate with the POTS
interface e.g. if the number 341317 was entered, then a normal telephone attached to
the POTS interface would be only rung when incoming call with the number of 341317.
run the ISDN100.INF file from the installation
à
ISDN PC Adapter, Properties
Fig. 3-3 ISDN T/A 128 Adapter configuration
à
Settings
à
Control panel
à
The MSN (POTS)
11
à
System
à
Settings.
value is only relevant to the
Device
Advertisement
Table of Contents
