Table of Contents
Advertisement
ATS50
ATS51
ATS53
ATS54
ATVn
ATV0
ATV1
ATXn
ATZ
+++
AT&Cn
AT&C0
AT&C1
AT&E
AT&E0
AT&E1
AT&F
AT&R
AT&S
AT&S0
AT&ZIn*m
AT&ZOn*m
AT#C
AT#C?
AT#C0
AT#C1
Window size of X.75 ISO 8208, 2 default
Packet size of X.75 ISO 8208 from 128 to 2048, 1024
default
Average data flow from 1000 to 7000 bytes (default 4, it
means 4000 bytes)
Active the second channel if average data flow is over
4000 bytes in 10 seconds. This register is only available
in MLPPP BOD mode, ATB43.
Time period from 5 to 20 minutes (default 5)
Disconnect the second channel if average data flow
below N bytes (set by ATS53) in 5 minutes. This register
is only available in MLPPP BOD mode, ATB43.
Verbose command
Return digit result code
returns word result code ( default )
Enable extended result code
Reset
Escape command
Control DCD
Keep always the DCD line ON ( the same as AT&C,
default )
DCD line is active if connected
Select the line speed in the B channel
64K bps (default)
56K bps
Reset registers to factory setting
Request to send
Handle DSR
Keep DSR always ON ( the same as AT&S )
Filter the incoming call and accept it when called party
number is the same as n and called party sub-address is
the same as m (option, * is the sub-address symbol)
Make a call with this caller party number (n * m).
the local telephone number, " *"
symbol, if needed (option), and " m" is the sub address
(option).
Caller ID setting
Display the current Caller ID mode
Disable Caller ID (default)
Enable Caller ID
42
" n" is
is the sub address
Advertisement
Table of Contents
