Table of Contents
Advertisement
it means driver will detect one of protocols depended on remote device. If
you want to use our MLPPP and MLPPP+BOD function for outgoing call, you
need to check " Enable Multilink PPP" and click " Advance" to select the
second NDISWAN port and configure the second channel as below.
To check the " Enable BOD" to enable MLPPP+BOD function with two
default parameters, data flow rate (1 Kbytes/sec) and Inactivity timeout (5
minutes). The system will start to establish the second channel if the average
data flow of the first channel exceeds 1 Kbytes/sec during the past five
minutes. At the 128K data connection, If the average data flow lower than 1
Kbytes/sec during past 5 minutes, the system will disconnect one B channel.
call or receive an incoming voice call, the system will automatically
disconnect one B channel to set up the analog voice connection.
To add another NDISWAN port for second channel and click " Edit" to
configure it. The Call No. is the remote telephone number, Call Sub Addr. is
the sub-address (leave it blank if phone company does not provide this),
MSN and SUB for bill as above.
For the MLPPP and MLPPP+BOD of incoming call, it almost the same as
outgoing call, except the filter function. The called number of incoming call
should match the MSN and/or SAD before accepting this call if filter is ON.
Please refer below figure.
Click the POTS and Properties if you get the ISDN board with POTS (A/B) port, you get
4.
below configuration window. Please refer the POTS descriptions from the sections of
Windows 31 and Windows 95.
During the 128K data connection if the user want to make a voice
28
Advertisement
Table of Contents
