Table of Contents
Advertisement
repeat
if %n = %attempts
display " Too many dial attempts" \n
abort
end
output " atdt" $number\13
%ok = [input 60 CONNECT]
%n = %n + 1
until %ok#
This completes the basic setup for ISDN access. You will also need to modify
3.
certain other parameters, such as dial number, login name, and password if
required. These parameters are application dependent and are not covered
any further here.
our local distributor for support.
Microsoft HyperTerminal
If you are trying to use the HyperTerminal of point to point or BBS connection, you
should choose or add a virtual modem which is attached to the ISDN ComPort. Please
refer to Chapter 3 about Installation of ISDN T/A 128 driver and setup for virtual modem
in Windows 95 system. Ensure that you use the ISDN (X.75 Transparent, 64K) Adapter
modems or use the universal modems but use the ATB3n command in Advanced
Settings to select the X.75 protocol. (see below)
At the receiving site, you should enter ATS0=1 to automatically answer incoming calls.
Note that the default protocol in the B channel is HDLC 64K with packet size 2048. If you
would like to change the B channel protocol use the following steps.
Go to extra setting field : Start à Settings à Control panel à Modems à
Properties à Connection à Advanced à Extra settings. Please see Figure 3-
If you use different the
TRUMPET version, you may contact
52
Advertisement
Table of Contents
