Wall Mount Plate Mounting - Planet ISW-802M User Manual

6-port 10/100mbps tp+2-port 100base-fx managed industrial ethernet switch

Table of Contents

Step2: Lightly push the button of DIN-Rail into the track.

Step3: Check the DIN-Rail is tightly on the track.

Step4: To remove the industrial switch from the track, reverse steps above.

2.2.2 Wall Mount Plate Mounting

To install the switch on the wall, please follows the instructions described below.

Step1: Remove the DIN-Rail from the industrial switch; loose the screws to remove the DIN-Rail.

Step2: Place the wall mount plate on the rear panel of the industrial switch.

Table of Contents