Wiring The Power Inputs - Planet ISW-802M User Manual

7
8
9
[NOTE]
1. When port alarm function is enabled, the fault LED will on and Alarm relay will activity when port failure
occurs.
2. Please restart the switch after the Redundant ring DIPswitch is set.
2.1.6 Switch Bottom Panel
The bottom panel of the ISW-802M consists one terminal block connector within two DC power inputs
and one DC IN power jack for extra AC/DC power adapter.
Figure 2-2 shows the bottom panel of the switch

2.1.7 Wiring the Power Inputs

Please follow below steps to insert the power wire.
Enable port 6 Alarm. If the port's link fails, the fault LED will
ON
light up.
OFF Disable port 7 Alarm
Enable port 7 Alarm. If the port's link fails, the fault LED will
ON
light up.
OFF Disable port 8 Alarm
Enable port 8 Alarm. If the port's link fails, the fault LED will
ON
light up.
OFF Disable the ring master function.
Enable the switch as the ring master in the redundant ring
ON
group.
Figure 2-2 ISW-802M Bottom Panel.