4. Installation
4.1 Wall Mount Installation
To install the Wall-mount Managed Switch on the wall, simply follow the following
steps:
Step 1: There are 4 holes with 8mm diameter on the wall; the distance between
the 2 holes is 133mm(WGS-804HPT/WGS-4215-8T), 163mm(WGS-4215-
8T2S) and the line through them must be horizontal.
Step 2: Install a conductor pipe inside the board hole and flush the edge of the
conductor pipe with the wall surface.
Step 3: Screw the bolts into the conductor pipe. The Wall-mount Managed Switch
is between bolts and conductor pipe, as shown below.
7