Toyota All Models Inspection Standards Manual page 12

MECHANICAL STANDARDS
AND PROCESS NOTES
Item
46 The brake system contains all needed equipment (shim kit, pins,
rattle clips, etc.).
47 Brake pad/shoe linings have a minimum thickness of 50% remaining.
48 Brake rotors/drums within specifications with no abnormal
grooving and discoloration.
49 Exhaust system is properly secured with no leaks.
50 Engine/transmission mounts operate properly with no signs of wear.
51 Drive/axle shafts operate properly with no damage.
52 CV joints/boots operate properly with no signs of wear.
53 Inspect engine for fuel, oil, coolant or other fluid leaks.
54 Inspect transmission case and pan for leaks.
55 Differential fluid level correct with no leaks.
Item
56 Perform emissions test and/or state inspection, if required.
III. Frame, Structure and Underbody
Criteria
IV. Emissions and State Inspection
Criteria
9
(Continued)
Comments
Many brake pads can be measured without removing wheels.
Check for excessive damage, such as dents or pulled seams that
expose unplated metal, extreme rust or exhaust leaks.
Inspect for oil leaks from CV joint boots.
Let engine idle and check for oil leaks. Inspect all brake fittings
and hoses for brake fluid leaks.
Some vehicles use hypoid gear oil while others may use ATF.
Check for signs of moisture.
Comments
Remain versed on your state and local laws.
Mechanical Notes 10/10