Firing Valve Disassembly/Assembly - Tippmann TPX Owner's Manual

(46) from Air Valve (23) (see
below).
Disassembly
5. Lift out the Magazine Release (4) Spring
(13), Safety (22) (at reassembly, the black
O-ring end goes into right receiver half);
Trigger (5), Trigger Pin (long) (33), Ball
Latch (24), Breech Window (16), Release
Actuator (3), and the Actuator Link (6).
6. Clean and inspect parts. Replace any
damaged parts. Use Tippmann grease to
lightly lubricate the Safety O-rings, Spring
(13), Trigger hinge (arrow above), and
Trigger Pin (33) to maintain your marker in
good working condition.
7. To reassemble, follow these instructions in
reverse and be sure the Actuator Pin (arrow, below right) is pushed in flush to the Firing
Valve Body as shown.
NOTE: Carefully hand start all threaded parts. Do not overtighten
and strip threaded parts when reassembling.
NOTE: Failure to reassemble correctly can cause damage to parts, air/CO2 leaks, and
other problems. As you reassemble your marker, double check to be sure parts are
clean, not damaged, lubricated, and installed correctly.

Firing Valve Disassembly/Assembly

1. Follow
Marker Disassembly/Assembly
2. Remove the Firing Valve (46) from the Air Valve (23),
by removing the 2 Screws (47) with a 3/32" Allen
wrench.
3. The 2 O-rings (45) are not attached.
NOTE: Be sure the 2 O-rings are in place when
reassembling the Firing Valve to the Air Valve.
4. Pull the Actuator Pin (51) out. NOTE: When
reassembling be sure this Pin is pushed in flush to
the Firing Valve body as shown.
5. Remove the Firing Valve Pin Guide (50) using a 3/32"
wrench.
6. Tap on the Firing Valve Body (46). Two O-rings (48)
and the Valve Bushing (49) should fall out (if you
need to pull the parts out, use a plastic tool so you do
not damage the parts).
7. Clean and inspect parts. Replace any damaged parts. Use Tippmann grease to lightly
lubricate the Spring (52) and O-rings (45 and 48) to maintain your marker in good
working condition.
8. To reassemble and reattach the Firing Valve to the Air Valve, follow these instructions
in reverse. NOTE: Carefully hand start all threaded parts and do not overtighten and
strip threaded parts when reassembling. NOTE: Failure to reassemble correctly can
cause damage to parts, air
marker, double check to be sure parts are clean, not damaged, lubricated, and installed
correctly.
Firing Valve
5
.
on page 14.
CO2 leaks, and other problems. As you reassemble your
/
15
Black O-
ring
Red
33
22 24 16
4
52
45
48
49
46
47
E
N
G
L
I
S
H
13 6
3
. .
.
23
46
50
51