Removing The Magazine And Loading; Firing The Marker; Unloading The Magazine - Tippmann TPX Owner's Manual

NOTE: If your marker does not fire after you have successfully loaded and punctured your
CO2 cartridge, put the trigger safety back into Safe mode (see page 4)
and go to Troubleshooting on page 19.
2.

Removing the Magazine and Loading

The barrel blocking device must be installed (see page 4) and the trigger
safety in Safe mode (see arrow at right and also see page 6).
a. To remove the Magazine, push in the Magazine Release
button and the Magazine ejects out the bottom of the grip.
b. The Ball Carrier inside the Magazine has two tabs, one on each
side of the Magazine. To load the Magazine, push down on the
Ball Carrier tabs until the Ball Carrier locks in place near the
bottom of the Magazine. (It automatically releases when inserted
into the marker.)
c. Keep the Magazine vertical as shown, and insert one paintball at
a time into the top of the Magazine. The Magazine holds seven
paintballs. Paintballs in the Magazine are not under pressure
until the Magazine is inserted into the marker.
d. To insert a loaded Magazine into the marker, slide the Magazine
into the grip until you hear it lock into place. Only remove the
barrel blocking device and change the trigger safety to Fire
mode when you are ready to shoot. Eye protection
designed for paintball use must be worn by the user and
any person within range. The Sight Windows allow you
to see when you are low on paintballs in the Magazine.

3. Firing the Marker

Eye protection designed for paintball use must be worn by the
user and any person within range. Point the marker in a safe
direction. Remove the barrel blocking device from the marker.
Move the trigger safety from Safe mode to Fire mode. Pull the
Trigger to fire the marker. Each pull of the Trigger fires one paintball

4. Unloading the Magazine

a. Eye protection designed for paintball use must be worn by the user and any person
within range.
b. Remove the Magazine from the TPX marker. When removing the Magazine,
two loose paintballs might drop from the grip. Inspect the breech chamber for a
paintball. The Breech Window (16) on top of the receiver provides a way to check
for a paintball in the breech chamber. Point the marker in a safe direction and pull
the trigger (dry fire) to clear the marker of any remaining paintballs. Put the trigger
safety in Safe mode (see page 6) and install the barrel blocking device (see page 4).
Not seeing a paintball in the Breech Window does not
indicate that the marker is unloaded or safe.
c. Push the Magazine's Ball Carrier down until it locks into place (see step 2.b. above)
to take pressure off any remaining paintballs in the Magazine. You can then reload
any loose paintballs into the Magazine.
WARNING
9
Magazine Release
Ball
Carrier
Tab
16
Sight Windows
E
N
G
L
I
S
H