Tippmann SIERRA ONE MARKER Owner's Manual page 11

Marker Disassembly / Assembly (continued from page 17)
Reassembling Receiver Halves:
STEP 1: ❏ Double check that the Trigger Assembly ( ❏ Trigger Spring
E
/ ❏ Safety / ❏ Pins (4)
N / ❏ Sear Pin* (black)
Spring*
+ ❏ Pin* + ❏ Spring*
G
; ❏ Linkage Arm* ; ❏ Link Arm Pins (2)
L
; ❏ Bolt Handle
Bolt Insert
I
; ❏ Buffer O-ring
Pin*
; ❏ 2 Tank Adapter Nuts
S
on pages 10-11 for details as needed).
H
Carefully hand start all
threaded parts and do
not overtighten and
strip threaded parts
when assembling.
STEP 2: ❏ Carefully install the left receiver half (make sure halves fit flush).
❏ Insert 3 short receiver bolts
❏ If marker has a barrel shroud
❏ Insert 3 long receiver bolts
❏ Attach adapter
tighten
bolt goes in front). ❏ Apply marker oil onto the barrel o-ring, insert
the barrel and carefully
❏ Slide the feed elbow
into the receiver and tilt up until the front sight
holds it in place.
❏ Slide the rear sight
on, insert bolt and tighten
/ ❏ Trigger / ❏ Sear
) ; and other parts: ❏ Front Sight
; ❏ Front Bolt* ; ❏ Ball Latch
; ❏ Rear Bolt*
; ❏ Drive Spring*
; ❏ End Cap + ❏ End Cap Cover
; are in place and (*=oiled) (see schematics
.
- insert it now.
and ❏ tighten
the 6 bolts
2 bolts (NOTE: short adapter
screw it in.
.
18
Reassembling Receiver Halves:
(continued on page 19)
Reassembling Receiver Halves: (continued from page 18)
❏ Press in the 2 magazine tabs
magazine
/ ❏ Sear
it in place. NOTE: The magazine may be used to
store tools and lubricating oil for your marker (shown
with 2 allen wrenches
+ ❏
+ ❏ Guide
/ .
and slide the
up into the marker until the tabs lock
and oil).
19
E
N
G
L
I
S
H