4 - 58 SE655 Decoded Linear Imaging Engine
Codabar
Enable/Disable Codabar
Parameter # 07h
To enable or disable Codabar, scan the appropriate bar code below.
Set Lengths for Codabar
Parameter # L1 = 18h L2 = 19h
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s) the code
contains. Lengths for Codabar may be set for any length, one or two discrete lengths, or lengths within a specific range.
One Discrete Length - Select this option to decode only those codes containing a selected length. For example, select
Codabar One Discrete Length, then scan 1, 4, to decode only Codabar symbols containing 14 characters. Numeric bar
codes begin on
page
64. To change the selection or cancel an incorrect entry, scan
Two Discrete Lengths - This option sets the unit to decode only those codes containing two selected lengths. For
example, select Codabar Two Discrete Lengths, then scan 0, 2, 1, 4, to decode only Codabar symbols containing 6 or
14 characters. Numeric bar codes begin on
on page
65.
Enable Codabar
(01h)
*Disable Codabar
(00h)
Codabar - One Discrete Length
page
64. To change the selection or cancel an incorrect entry, scan
CHS 7Ci, 7Di, 7DiRx Command Barcodes
Cancel on page
65.
Cancel
54