Socket CHS 7Di Command Barcodes page 4

Bluetooth cordless hand scanner (chs) 1d imager models

Hide thumbs Also See for CHS 7Di:

Table of Contents

ENABLE Automatic Reconnection from CHS (default)

Configures the CHS to automatically initiate a connection to the last paired computer / device

after the CHS is powered on.

DISABLE Automatic Reconnection from CHS

Configures the CHS to wait for a computer / device to initiate a Bluetooth connection after the

CHS Is powered on.

After scanning the Enable/Disable Automatic Reconnection from CHS command barcode above, power off and

power on the CHS to make sure it is configured properly!

Factory Reset

Configures the CHS to revert all settings to factory defaults. The CHS will power off after

scanning this barcode.

Data As Is

Configures the CHS to return only the

decoded data (i.e., no prefix or suffix).

Suffix – Carriage Return (default)

Configures the CHS to add a carriage return

after decoded data.

Suffix – Line Feed

Configures the CHS to add a line feed after

decoded data.

Suffix – Carriage Return & Line Feed

Configures the CHS to add a carriage return

and line feed after decoded data.

Suffix – Tab

Configures the CHS to add a tab after

decoded data

Automatic Reconnection Settings

Factory Defaults

Data Suffix — For HID Mode

Command Barcodes for CHS 7Ci, 7Di, 7DiRx

Table of Contents