Power On Function; Onboard Fdc Controller; Onboard Serial Port 1; Onboard Serial Port 2 - Albatron PX845EV1 Series User Manual

Power On Function

This option allows you to select a way to power on your computer.
Options: Password、Hot KEY、Mouse Left、Mouse Right、Any KEY、BUTTON ONLY
(default), and Keyboard 98
KB Power On Password
Supply a password that your system will use as part of the power-on sequence.
Hot Key Power ON
This option allows you to use the Ctrl key along with a hot key (function key) to power on
your system. Options: Ctrl-F1、Ctrl-F2...... Ctrl-F12

Onboard FDC Controller

Select "Enabled" if your system has a floppy disk controller (FDC) installed on the system
board and you wish to use it. If you install an add-in FDC or the system has no floppy drive,
select "Disabled". Options: Enabled (default)、Disabled

Onboard Serial Port 1

Select an address and corresponding interrupt for the first serial port.
Options: Disabled、3F8/IRQ4 (default)、2F8/IRQ3、3E8/IRQ4、2E8/IRQ3、Auto

Onboard Serial Port 2

Select an address and corresponding interrupt for the second serial port.
Options: Disabled、2F8/IRQ3 (default)、3F8/IRQ4、3E8/IRQ4、2E8/IRQ3、Auto

UART Mode Select

This item allows you to select the Infra Red (IR) standard to be used.
Options: Normal (default)、AS KIR、IrDA
RxD, TxD Active
This item determines the RxD and TxD frequencies.
Options: Hi / Lo (default)、Hi / Hi、Lo / Hi、Lo / Lo

IR Transmission Delay

This item allows you to enable/disable IR transmission delay.
Options: Enabled (default)、Disabled

UR2 Duplex Mode

Select the transmission mode used by the IR interface. Full-duplex mode permits
simultaneous bi-directional transmission. Half-duplex mode permits transmission in only
one direction at a time. Options: Half (default)、Full
PX845EV1/ PX845EV1 PRO
38