Albatron PX845EV1 Series User Manual page 22

Floppy Disk Connector: FDC
This mainboard provides a standard floppy disk connector (FDC) that supports 360K, 720K,
1.2M, 1.44M and 2.88M floppy diskettes. This connector supports the floppy drive ribbon
cables provided in the packaging.
Hard Disk Connectors: IDE1/ IDE2
This mainboard has a 32-bit Enhanced PCI IDE Controller that supports PIO Mode 0~4,
Bus Master, Ultra DMA / 33, Ultra DMA / 66,and Ultra DMA / 100. It has two HDD
connectors, IDE1 (primary) and IDE2 (secondary).
IDE1 (Primary IDE Connector)
You can connect up to two hard drives to IDE1. If you attach two drives, you must use a
ribbon cable with three connectors. You must also configure one drive as the master and one
drive as the slave, using the jumpers located on each drive.
IDE2 (Secondary IDE Connector)
The IDE2 controller can also support a Master and a Slave drive. The configuration is
similar to IDE1. The second drive on this controller must be set to slave mode.
FDC
PX845EV1/ PX845EV1 PRO
DIMM1
DIMM2
DIMM3
ATX_PWR
IDE2
IDE1
The layout is PX845EV1 PRO
18